[The premise of energy saving, it is necessary to do a good job of thermal insulation]
Whether the use of electric floor heating costs electricity, in addition to the daily opening and use, it is more important to pay attention to whether there are thermal insulation measures in the heating area in the early stage. It is necessary to know that the quality of insulation measures directly affects energy consumption, so if you want to save electricity, first check whether the insulation work is in place~
1. Use thermal insulation materials with good thermal insulation properties. The floor heating extruded board is laid under the floor heating to keep heat and heat insulation, and the heat of the floor heating will be less likely to be lost.
2. During decoration, the sealing of doors and windows should be strengthened. It is advisable to use double-layer insulating glass, thicker curtains, etc. As a result, the energy saving effect is very significant.
3. Appropriately take thermal insulation measures on the walls and ceiling before decoration, which can prevent the loss of heat in the home.
4. Partition doors should be installed on non-heated balconies and indoors. Otherwise, it is equivalent to throwing heating bills out the window!

【Operation guide for daily use】
1. You don’t need to turn off the thermostat when you go out that day, and don’t let anyone turn it on and off. It can be set to a low temperature maintenance state. The energy consumption in this state is much less than the power consumption of heating the room from 0°C to 10°C.
2. After going out and returning home, adjust the temperature controlled by the thermostat to the normal expected value.
3. The temperature can be appropriately lowered in areas that are not often used or unoccupied.
4. If you go out for more than 2 days, you can turn off the thermostat to ensure energy saving and safety. After returning home, first enable the system according to the initial use method, and then resume the daily use mode after the system runs normally.
5. The temperature can be adjusted reasonably according to the time period of peak and valley electricity. Take advantage of the price difference between peak and valley electricity, make full use of valley electricity, and save heating expenses.

【Please also pay attention to the following points】
1. It is recommended that the furniture in the house use furniture with legs to help heat conduction.
2. Reasonable allocation of power. If the power configuration is too small, the room temperature will never reach the set temperature, and the floor heating will keep working to reach the set temperature, which will waste more energy. Excessive power has an impact on the overall electricity load of the home, increasing energy consumption and causing wastage of electricity bills.
3. Set the room temperature correctly and reasonably. For general residences, according to the national heating standard, the bedroom, living room and living room can be set between 18-20℃.
4. It is recommended to keep the system turned on when leaving for a short time. Otherwise, the room needs to be re-warmed when the system starts up again, which will consume a long time and power. For example, when going out for no more than 48 hours, it is recommended to use the low temperature operation mode, and the temperature can be set at about 12°C. Compared with intermittent heating, continuous heating will be more energy-efficient.
The heating of the home environment requires a heat storage process. When the electric floor heating is turned on for the first time, due to the high moisture content of the concrete protective layer on the ground, if it is operated at a high temperature immediately, it may affect the ground floor or floor tiles. Therefore, we recommend that the temperature should not be set too high for the first use in winter every year.